FLUID FILM

STOPTS
RUST
IMMEDIATELY

FLUID FILM NAS

VISCOSITY: low-medium (eg. like ketchup)
CREEPABILITY: + + +
DURATION: ca. 8 years (in closed cavities)
PROCESSING: with conventional compressed air systems to heat the material to about 25 ° C or with airless systems

FLUID FILM NAS is a physiologically harmless, solvent-free and thixotrophic single-layer corrosion protection coating with sliding and rust-dissolving effect based on lanolin. It forms a clear and shiny protective film.

APPLICATIONS

FLUID FILM NAS is mainly applied as rust protection of metal surfaces during internal interim storage, for preservation during sea and road transport and for cavity sealing of motor vehicles. It can also be used as a lubricant and creeping agent as well as in winter service.

In conventional processing by means of sprayers, brushes or rollers for corrosion protection measures on dry or damp, bare or rusty surfaces, which are to be protected against salt water and weather influences. For cavities on motor vehicles, FLUID FILM NAS can be used by means of a pressure cup gun with a cavity probe (0.2 or 0.4 mm) after heating to approx. 25°C.

THICKNESS

The effectiveness of a rust protection system depends, among other things, on its layer thickness. It has to be selected according to the given stress and the service life of the object.

We recommend double the layer thickness when protecting cavities with many corners, rebates and overlaps and the presence of an old coating or flash rust.

Surface Preparation

FLUID FILM NAS can be used as a rust remover and at the same time as a corrosion inhibitor. For economic reasons, it is recommended to remove loose dirt such as rust and old coating parts by washing them out. The surface may be moist, but must be cleaned of surface water.

EFFECT

solvent-free and physiologically harmless during application and as a protective film;
requires minimal surface treatment, penetrates rust, displaces water and forms a highly resistant protection against corrosion by salts
good adhesion to damp or dry surfaces
no evaporation, resinification or drying out of the protective film
can be easily removed if necessary
may come into contact with water immediately after application

Packaging

1 litre plastic bottle
1 litre cartridge
5 litre plastic canister
20 litre pail
208 litre drum

BROCHuRE (PDF)

For a full screen view, click on the diagonal cross.
To download the PDF, click on the 3 dots on the left and then go to “Download”.

back